RCC remote connections

dkurfurst · Post by **dkurfurst** » Thu Sep 22, 2005 10:18 am

I am planning on using RCC on a laptop that I use when I travel to all of my different office locations. The problem that I have is I am using DHCP at my locations and have no way of knowing what my IP address will be untill I am at that location. Is there a way to setup a profile that will allow me to connect from an entire subnet ? Can I specifiy 10.1.1.0/255.255.225.0 or some thing else ?

KS-Soft · Post by **KS-Soft** » Thu Sep 22, 2005 12:23 pm

http://www.ks-soft.net/hostmon.eng/news.htm#v562

HostMonitor: now you may use '0.0.0.0' IP address in "Accept remote connections from" list (User Profiles dialog). If you specify 0.0.0.0 address, HostMonitor will accept incoming connections from ANY address

Regards
Alex

plambrecht · Post by **plambrecht** » Wed Sep 28, 2005 5:17 am

0.0.0.0 is nice, but 10.1.0.0/255.255.0.0 would me much much nicer !

P.

KS-Soft · Post by **KS-Soft** » Wed Sep 28, 2005 11:16 am

The same "what's new" page says

HostMonitor: now you may specify ranges of IP addresses from which a connection may be accepted

So you may type 10.0.0.1 - 10.255.255.255
There is one peculiarity: if you want to allow addresses below AND above 128.0.0.1, you should use 2 ranges 0.0.0.0-127.255.255.255 and 128.0.0.1-255.255.255

Regards
Alex

dkurfurst · Post by **dkurfurst** » Thu Oct 13, 2005 10:03 am

Thanks I got it working using the 10.x.x.x-10.x.y.y

RCC remote connections

RCC remote connections

address range