Logging of multiple event log triggers

Guido39 · Post by **Guido39** » Thu May 15, 2003 2:37 pm

I am monitoring event logs for a specific trigger and it logs just fine if there is only one event triggered between test times. But, if there are two or more, it only logs the first one. In the test setup, I do have "report about all bad events" checked and I see the two different triggered events change in Host monitor. It just won't log both of them.

KS-Soft · Post by **KS-Soft** » Thu May 15, 2003 3:00 pm

Set "save all information" option on Log Settings page in the Options dialog

Regards
Alex

Guido39 · Post by **Guido39** » Thu May 15, 2003 5:25 pm

That fixed the original problem but caused more problems. It now logs every test there is every time is checks whether it's good or bad. With hundreds of tests, and some checking every 30-60 seconds, it's filled the logs up very quickly.

Is there another way to fix the original problem without logging every test whether good or bad?

KS-Soft · Post by **KS-Soft** » Thu May 15, 2003 5:45 pm

Please
- download update from http://www.ks-soft.net/download/hm369g.zip
- replace exe module to new one
- change global logging option back to "save if host status changes"
- open Test Properties dialog for NT Event Log test that you use and change logging option to Full (just for this test).
HM will records information about all performed checks (even when status is Ok) but just for this test.

Regards
Alex

Guido39 · Post by **Guido39** » Fri May 16, 2003 8:27 am

That fixed it. Thanks again for such a quick response.